Shop Tour
Welcome to my shop!
This page may take a minute or two to load, but I thought you might like to see my recently revised layout. Besides, it usually isn't this clean.....
Left Side: Small wheel grinder, Paragon furnace, Craftsman bandsaw, tool boxes, workbench, and file cabinet.
Right Side: 8 inch drill press, horizontal disk sander, 12 inch drill press, shop made buffer, and sandblast cabinet. The red cover against the back wall is covering an Atlas lathe.
Not shown are a 1 hp dust collector and air compressor.
Above is a view of my workbench. On the left side of the bench is my metal cutting bandsaw (a portable bandsaw that I converted) and a small 1x30 sander I use for chamfering pin stock.
Toward the right rear of the bench is the worlds smallest reciprocating sander (more on that later).
At the right are two flex shaft tools.